Featured Products
Steel Rule Metric & Imperial
A high quality ground stainless steel rule. Quality etched and filled graduations. Single sided, metric/imperial.
from £0.99 inc VAT
Planet CF1 Centre Finder
Robust plastic construction. Used to mark the centre of work up to approx 8” diameter.
May also be used on square section.
Planet Dividers
Carefully selected range of Rotur Dividers suitable for measuring between two points, scribing circles prior to turning, marking along a spindle, etc. Fine adjustment.
Planet Inside Calipers
Carefully selected range of Rotur inside calipers suitable for measuring internal dimensions when turning. Fine adjustment.
Planet Outside Calipers
Carefully selected range of Rotur outside calipers suitable for measuring external dimensions when turning. Fine adjustment.
Marking Gauge 150mm
Mark perfect joints every time. The extra sharp replaceable cutter is hardened and marks a keen accurate line, preventing grain tear out during material removal. Up to 150mm depth of adjustment. Lightweight aluminum body with bright brass standard face. Engraved inch measurements on precision ground shaft.
Planet 3 (75mm) Steel Centre Square
Planet 3″ Steel Center Square, ideal for precision center-finding in engineering tasks or spindle marking
Planet Depth Gauge 6 Inches
Traditional design. Full 6” / 150mm depth check. Etched and filled rule.
Planet Drill Gauge 2 Piece Set Metric and Imperial
The Planet Drill Gauge 2 Piece Set is a precision tool designed for drilling and hole-sizing needs, suitable for professionals and DIY enthusiasts.
Planet Marking Gauge Rosewood
The marking gauge is made of selected rosewood with a protective lacquered finish, fitted with a brass knurled screw for more robust use. The gauge will mark with or across the grain.
Planet Mitre Square
This Mitre Square has spring steel blade secured to a double brass faced rosewood stock with four brass rivets. The tool is used for the accurate marking of mitre joints at 45 degrees or 135 degrees.
Planet Mortice Gauge Rosewood
Mortice gauge performs two operations. One side of its posts has a single pin for general marking with the grain or on end grain; its other side has double pins adjustable to approximately 50mm for layout of mortices. Made with solid brass hardware, wear plates, and fitted with milled thumb screw in head. Overall length 200mm.
Planet Protractor
Stainless steel protractor with high quality, clear, black graduations. Incorporates a 6” / 150mm rule. Degrees are marked from both ends of the scale.
Planet Rotur Compass/Divider With Pencil Holder
Accurate Diameter Measurement: Easily measure turning blanks and workpiece diameters with precision for consistent woodturning results.
Effortless Circle and Arc Drawing: Create flawless circular and arc-shaped designs, making it an invaluable aid in shaping wood pieces.
Planet Steel Square
Conforms to BS939. Suitable for general workshop use.
Planet Try Square
Try square stock is made from best quality rosewood, spring steel blade & double brass facings. The blade is securely held by three brass rivets. Try squares are available in two sizes and can be used as external & internal square.
Planet Universal grinding gauge
Assists in the regrinding of hand tools, drill bits, etc. Angles include: 90 degree int, 90 degree ext, 55 degree int, 60 degree int, 60 degree ext and 120 degree int. Made from stainless steel with clear, etched and inked graduations
Steel Rule Metric & Imperial
A high quality ground stainless steel rule. Quality etched and filled graduations. Single sided, metric/imperial.
Vernier Depth Gauge 8"
This new depth guage has been designed for Planet with metirc and imperial measurements along the heavy duty rule and is tightened in place by a knurled thumbscrew through the body. Comes in a neat wooden box
Depths of up to 8″/200mm can be measured.